Pavement Marker Blades

Plunge Cut Rider Saw - For Raised Pavement Marker Installation

From line irradication to inlay/overlay tape installations & from raised pavement marker installations to single blade sawing (up to 54" blade) - our rider saw has the power and versatility to handle all your projects. Dynatech has over 28 years experience in the pavement marking industry. You know it's built powerful enough and tough enough to get the job done right when it's from Dynatech.

Features:

  • 78hp turbo deutz deisel engine
  • electric start
  • forward/reverse
  • hydraulic driven blade shaft
  • adjustable depth stop
  • quick disconnect blade guard
  • heat exchanger for hydraulic oil utilizing air for cooling
  • variable rpm with NO horsepower loss
  • accommodates blade set-ups for any marker installation
  • easily converts to single blade cutting 14" through 54"
  • converts from a down cut to an up cut saw in less than a minute
  • arm mounted blade raises and lowers easily(while engine and operator stay level)

Saw easily converts into:

  • Floating Head Saw for tape installtion/line removal
  • Slot Cutting Saw for recessed/bannana/taper cuts
 Plunge Cut Rider Saw Specifications:
 Maximum width of cut: 7 "
 Maximum depth of cut: adjustable for any marker/tape install
 Blade guard capacity: 14" - 54"
 Blade shaft diameter: 2-1/2"
 Arbor diameter: 1-3/4" with dual drive pin
 Blade shaft bearings: precision ball
 Blade shaft drive: hydraulic motor
 Blade mounting: right
 Blade raise and lower: hydraulic pump, solenoid valve controlled
 Blade coolant: dual multi spray tubes
 Blade guard attachment: slip-on/bolt-on
 Front wheel dimensions: 10" x 4" x 1-1/4"
 Rear wheel dimensions: 12" x 6-1/2" x 8"
 Transmission: variable displacement hydraulic pump and motor
 Drive system: direct/hydraulic
 Air filter: 4 stage
 Fuel capacity: 9 gallons
 Electric start: standard
 High temperature shut-off: gauge/light
 Low oil alert: warning light
 Hour meter: standard
 Tachometer: standard
 Amp meter: warning light
 Adjustable depth stop: standard
 Blade shaft wrench: standard
 Quick disconnect blade flanges: standard
 Hydraulic oil capacity: 16 gallons
 Plunge Cut Rider Saw Dimensions:
 Saw Height: 67-3/4"
 Min. Length Pointer Up: 82"
 Max. Length Pointer Up: 129-1/4"
 Frame Width: 45"
 Frame Length: 58"
 Saw Width: 64-5/8"
 Front Axle Center Length: 39-7/8"
 Rear Axle Center Length: 20-3/4"
 Wheel Base Length: 47-1/2"
 Blade Shaft Max Height: 31-5/8"